Use and maintenance manual Self-propelled aerial platforms Page 13
3.3
Safety rules
3.3.1
General
Only adults, after carefully reading this manual, are allowed to use the machine.
Use the machine at a distance of at least 5 metres from high-tension lines (in any case not in
proximity to live elements).
Use the machine according to the capacity values indicated in the technical features section. The
max. No. of people allowed on the platform and the capacity are specified on the identification plate.
The use of the levelling jacks does not increase the unit capacity.
It is absolutely forbidden to load persons, tools and building materials on the platform when it is not
in access position.
DO NOT use any machine elements for ground connections while welding on the platform.
When using the levelling jacks, before lifting the platform, always check that the unit rests on four
points (pads and wheels or pads only). An automatic system inhibits platform lifting in the event
that one of the pads does not rest properly on the ground.
Do not use the units with Thermic power (models "-D"; "-B" and "-B/G") indoors or in insufficiently
ventilated areas.
It is the machine owner and/or safety manager’s responsibility to check that the operators have
been thoroughly trained in the use of the machine.
It is the machine owner and/or safety manager’s responsibility to check that the maintenance and
repair operations are carried out by skilled personnel.
3.3.2
Handling
Before any movement make sure that the machine plugs are disconnected from the power source.
Machines with levelling jacks are equipped with four microswitches that inhibit drive when the
levelling jacks are not perfectly retracted.
In order to avoid any instability, use the machine on regular and firm grounds. Before lifting the
platform check the platform level through the spirit level which is located on the platform. To
prevent the machine from overturning, comply with the max. gradeability values indicated in the
Technical features section under paragraph "Stability limits". However, movements on inclined
grounds are to be carried out with the utmost caution.
As soon as the platform is lifted (the tolerance varies according to the model) the safety drive speed
is automatically activated.
Drive the unit with lifted platform only on flat grounds, verifying the absence of holes or steps on
the floor and bearing in mind the overall dimensions of the unit.
While driving the unit with lifted platform the operators are not allowed to place horizontal loads
onto the platform (operators on board must not pull ropes, wires, etc.).
The machine must not be used directly for road transport. Do not use it for material transport (see
paragraph 1.2 “Intended use”).
Check that in the operating area there are not obstacles or other dangerous elements.
Pay particular attention to the area above the machine during lifting to avoid any crushing and
collisions.
