21
Installation
Installing the charging stand
Connecting the power adapter to the charging stand
1
Connect the power adapter to connector terminal on the rear side of the charging stand
Hook the cable
N o t e s
• Set the master station on the charging stand when it is not in use.
• Use the charging stand after placing it on a table or hanging it on a wall.
• Do not install the charging stand on a tilted surface. Otherwise, it may not be able to charge
correctly.
When hanging the charging stand on a wall
•
When hanging the charging stand on the wall, attach it securely to avoid to fall.
Falls may cause damage or injuries.
* Avoid weak wall surfaces, such as drywall, autoclaved lightweight concrete (ALC), concrete
blocks, and plywood with a thickness of 18 mm or less.
•
When the charging stand has been hung on a wall, do not place heavy objects on the
charging stand or lean on the charging stand.
This may cause damage or injuries.
Caution
1
Attach the included wood screws x2 to a wall or pillar, and then hang the
holes of the charging stand on the wood screws to secure it.
Approx. 30 mm
(Dimensional guideline on the right)
Groove
Correct
Incorrect
Wood screw
Wall (pillar)
Approx. 3 mm*
Hook the cable
Hook so that the screw completely fits
in the groove of the upper section of
the hole.
* If necessary, adjust the depth of
the wood screw so that the
charging stand does not rattle.
A
p
p
rox
. 3
0 m
m
R
e
fe
re
n
ce f
o
r
at
ta
ch
m
e
nt
h
o
le
wid
th
