19
Installation
Installing the video door station
1
Remove the mounting frame from
the video door station
Locking
screw
Loosen the locking screw on the bottom and
remove the frame.
2
Remove the battery cover
Battery cover
Loosen the two screws and remove the
battery cover.
3
Insert six AA batteries (batteries
not included)
Align the plus (+) and minus (-) terminals
correctly.
4
Attach the battery cover
Tab
• Set the hooks of the upper section of the
battery cover and attach the battery cover.
• Tighten the two screws.
• There is rubber packing attached to the
rear side of the battery cover. Make sure
that the rubber packing is not removed
during attachment.
5
Adjust the camera angle
0°
(facing front)
Camera angle
adjustment lever
+19°
(facing up)
Camera angle
adjustment lever
The camera angle can be adjusted from 0°
through 19°.
6
Attach the mounting frame to a wall
83.5 mm (3-5/16")
(Dimensional guideline on the right below)
Mounting height: approx. 1,450 mm
(device center)
Secure the stand using the two included
screws or wooden screws.
*Refer to “Camera range and mounting
position”. (Page 20)
7
Attach the video door station to
the mounting frame
Insert the top section of the video door station
into the mounting frame and push in the
bottom section. Tighten the locking screw on
the bottom to secure the video door station.
N o t e s
• Do not use wood screws when
attaching to a switchbox.
• Moutning may not be possible
depending on the wall surface.
83
.5
m
m
R
e
fe
re
n
ce f
o
r
a
tt
a
ch
m
e
n
t h
o
le w
id
th
