Page
84
of
125
Examples
This is what the ‘Operator Scans’ example looks like once set up in 4.5.8 Barcode Configuration
Screen.
Airbag Install
The customer wants to track the serial number of each airbag being installed, as well as, the
operator installing it. When the operator reports to the station, they will scan their employee ID.
When the vehicle comes into the station, the operator scans the VIN of the vehicle and the serial
number of the airbag. Once all three scans are received, the tool is enabled. Once the correct
number of fasteners are installed, the tool is disabled by the job settings. From that point, the
operator only needs to scan the vehicle and the airbag to enable the tool.
Setup
We will assign the employee ID to ID#1, the vehicle VIN to ID#2, and the airbag serial number to
ID#3. Scanning a new employee ID will reset the other IDs and force a scan of the vehicle VIN
and airbag serial number. The scan of the vehicle VIN will also select the correct job number.
Mask
Store to
Action
Reset ID
ID#1 ID#
2
ID#
3
ID#4
“EMP….”
ID#1
None
No
Yes Yes
No
“VIN…..…”
ID#2
Select
Job#
1 No
No
No
No
“SN….…”
ID#3
None
No
No
No
No
Once all three scans are received, the tool will be enabled.
Required Identifiers for Tool Enable
ID#1
ID#2
ID#3
ID#4
Yes
Yes
Yes
No
When job is complete, the vehicle VIN will be reset and the airbag serial number, but not the
employee ID; this way subsequent vehicles will only require a VIN and S/N to enable tool.
Reset Identifiers on Job Complete
ID#1
ID#2
ID#3
ID#4
No
Yes
Yes
No
This is what the Airbag Install example looks like set up in 4.5.8
Barcode Configuration Screen.
