6
Figure 1a: Back View - 110VAC Power Connections
4.2.2 Using the Right Angle Power Connector
To use your own power leads, a Right Angle Power Connector (C) may be used (Not Included) see
Figure 1a
.
1.
After a qualified electrician wires the right angle connector (C), plug the connector into the power receiver (B) located on
the back of the NPVD.
4.2 Power Connections 110VAC
If your unit uses a 110VAC/60Hz Power Supply see either
Section 4.2.1 or 4.2.2
(as applicable for your instllation depending
on the way the power will be directed to the unit.
4.2.1 Power Connection with provided Cord
The NPVD can be powered with the included Power Cord (A) by plugging directly into the power receiver (B) located on the
back of the monitor see
Figure 1a
.
Power Cord Protection -
Power supply cords should be routed so that they are not likely to be pinched by items placed
upon or against them, paying particular attention to cords and plugs and the point where they exit from the appliance.
C
B
A
4.
INSTALLATION
Attention: Installations should be performed by qualified service personnel only in accordance with the
National Electrical Code or applicable local codes.
4.1 Mounting
For specific directions on mounting the Monitor see the Instruction Book that came with your mount.
Use eight (8) #10-24 screws when mounting the NPVD unit to your mount. Ensure that the mounting screws do not exceed
0.500 inches in length.
