7 Usage
- 29
–
➢
The display
1
of the data logger will show the home screen.
➢
The display
1
of the data logger will show the home screen and the
ON LED
2
of the data logger flashes as long as the data logger is
being charged.
➢
The ON LED
2
of the data logger is lit as soon as the batteries are
fully charged.
2. Switch the wireless sensor on by pressing and holding the ON/OFF
button
14
of the wireless sensor.
➢
All LEDs of the ALMEMO
®
wireless sensor are lit; the ALMEMO
®
wireless sensor is being switched on.
➢
The green LED of the ALMEMO
®
wireless sensor is lit and flashes
only briefly as long as the batteries are being charged. The ALMEMO
®
wireless sensor has been switched on.
➢
The blue LED is flashing. The wireless sensor is trying to establish a
connection to the data logger by using the saved pairing data.
In case the red LED flashes approximately 7 times, the wireless
sensor could not establish a connection with the data logger. The
wireless sensor continues to try to establish a connection with the
data logger while the blue and the green LED are slowly flashing
simultaneously.
If no connection could be established after a while, it might be
because no pairing data for this sensor is saved on the data logger.
Please check if the sensor is listed in the table in the menu
Settings>Wireless network>Sensor pairing.
If the sensor is not listed in this table, delete the pairing data saved
on the wireless sensor (7.1.8 How to terminate the Connection
between Wireless Sensor and Data Logger, section Delete pairing
data in wireless sensor without connection). Afterwards pair the
wireless sensor with the data logger (see chapter 7.1.7 How to
connect the Wireless Sensor with a Data Logger, section Pair
wireless sensor with the data logger).
➢
The measuring channels will gradually be listed in the menu Channel
List, in the menu Measured Value Display, and in the menu Sensor >
Measuring Channels. All measuring channels will be displayed
