Ahlborn ALMEMO 204, Operating Instructions Manual, Page: 16 / 72

6. Putting into service
6. PUTTING INTO SERVICE
Sensor connection Connect sensors to sockets M0 to M1 (1) s. 8.
Power supply via batteries or mains adapter at socket
DC
(3)
s. 7.1, 7.2
To switch ON Press
ON / PROG
(5) once and release s. 7.5
Automatic display of last measuring menu
s. 11.
For menu selection
press key:
<MENU>
On / off display illumination:
<  ON>
/
<  OFF>
Select
sensor list
s. 9.1 menu
<F> : ▲ / ▼
...
Call up a menu:
► or. PROG
Select a sensor (s. 10)
▲ / ▼
...
Display sensor:
<M◄◄>
Select a measuring channel (s. 11.1.1)
<M> : ▲ / ▼
...
All channels on the connector or those functions needed
for measured value calculation are displayed.
Data logger functions:
(s. 11.4)
Select Menu U2 data logger :
<MENU> , ▼ .. , ►
Select
memory cycle PROG , ▲ / ▼ ...
Using the scan cycle:
For V6 set 'scan time':
<SCANT>
For D7 set 'minimum time':
<MIN>
Return to output cycle ( 00:01:00 ):
<RESET>
Enter the cycle ( s. 9.5) :
PROG , ▲ / ▼ , ► ..
Terminate programming mode:
< ESC>
Start / stop measuring:
<START> - <STOP>
Output via an interface to a printer or computer:
- Connect peripheral equipment via data cable to socket
A1
(2)
s. Man. 5.2
Select
free memory
:
PROG
,
▼
...
Output memory s. 14.5.6
< PMEM> or command ´P04´ from the computer
Delete memory content s. 14.5.6 < CMEM > or command ´C04´ from the computer
16 ALMEMO ® 204