Process control
Set scan cycle to minimum time
<MIN>
00.001
Set scan cycle to scan time
<SCANT>
00.100
Select output in scan cycle
▼
00.002
s
-
Activate output
<ON>
00.002
s
U
Select and activate save-to-memory at the scan cycle in the data logger func-
tions (s. scan configuration 14.5.7).
16.7.3 Output cycle
For measured value output via the interface at a relatively prolonged cycle (> 1
second) 'output cycle' in format hh:mm:ss is provided. The output cycle can
also be used for determining cyclic average, maximum, or minimum values.
If a channel is programmed to averaging mode CYCL, average, max-
imum, and minimum values are all deleted with each cycle.
Enter an output cycle in format
hh:mm:ss
:
Output cycle:
00:01:00
s U
Zero-set cycle for manual measuring operation
<CLR>
Reset cycle to 1 minute
<RESET>
There is no longer a choice of output formats because the expanded range of
values can only be expressed in table format (see Man. 6.6.1). This format is,
as always, ideally suitable for further processing with any standard spread-
sheet program (see Man. 6.1, printouts).
16.8 Hysteresis
The hysteresis for an alarm triggered in the event of a limit value infringement
can be set generally for all sensors from 0 to 99 digits (default 10 digits) in the
Hysterese
function (s. 15.5, Man. 6.2.7).
Modify hysteresis
(0 bis 99) s. 9.5:
Hysteresis: 10
16.9 Operating parameters
Certain operating parameters can be configured by the user as software op-
tions in the function
Configuration
(s. Man. 6.10.13.2).
Delete all measured values at the start of a measuring operation
Configuration: -C------
Immediate output via the interface (oversampling)
Configuration: ----A---
Program the configuration
PROG
Configuration: -C------
Select a parameter
►
and
◄
Switch the parameter ON / OFF
▲
and
▼
ALMEMO
®
204
57
Summary of Contents for ALMEMO 204
Page 72: ...20 Annex 72 ALMEMO 204...
