<<
>>
PVDF
315
3.1
Version April 2008
EN
17
agru SP 315-S User’s Manual
button from the left, the welding parameters for 315 mm PDVF pipe with
another wall thickness can be entered, and all other “Input” buttons allow
entering the parameters for PVDF pipe with other diameters.
As soon as one of the “Input” buttons was touched, Display 9 shows.
From this screen, it is possible to edit in various ways the specific data
“branch” of which the “Input” button was
used to access Display 9. The button “New
Parameters” allows entering from scratch
all welding parameters for this branch in the
data “tree” of which the “Input” button was
touched. Data input proceeds as described
at the beginning of section 4.5: from the
name of the pipe material through to the
temperature the facing force.
Touch the “Edit Parameters” button to
change the value of a single welding pa-
rameter in the appropriate data “branch”.
Touching this button will let you access a
screen in which the parameter you want to
change can be selected from all the key data
that need to be defined. From that screen,
an input screen is accessed in which the value can be changed; then
confirm the change by touching the “Ok” button.
The “Delete Parameters” button can be used to delete that “branch” of the data
“tree,” of which the “Input” button was used to
access Display 9. Deleting has to be confirmed
in another safety message, and then the key
data for welding the material, from joining force
to plate temperature, are deleted along with the
appropriate wall thickness or SDR. If this wall
thickness or SDR is the only one left for the
pipe diameter in question, then the diameter
is deleted from the data “tree” too. And if the
thus deleted diameter is the only one left for
this pipe material, the entire “tree,” including
the material itself, is deleted.
By touching the “Delete Parameters Com-
pletely” button, it is possible to delete the
parameter of
all
additional, user-defined
pipe materials. Here too, deleting is possible
only after cofirming it in a safety message. After deleting them, only the
default materials with which the machine is shipped, remain.
Info
If the material that was used in the last welding operation is
deleted, then the next welding operation of necessity requires
a new material to be selected for welding.
4.6 Welding
Process
Important
The welding machine operates in two-hand mode at any time.
For any step in the welding process that may put the operator’s
hands at risk of injury because the carriage starts moving, the
operator must confirm the step on the touch screen and use
the second hand to keep pressed the green confirmation push
button on the machine front.
4.6.1 Facing the Pipe Butts
In the input screen reproduced in Display 5, when the “Ok” button was
Material Input
Ok
Cancel
Material
d [mm]
S [mm]
SDR
Input
Input
Input
Input
Input
Input
Options for Welding Parameters
Cancel
agru SP 315-S 26.04.08 14:55
+16°C
agru SP 315-S 26.04.08 14:55
+16°C
New Parameters
Edit Parameters
Delete Parameters
Delete Parameters Completely
Display 8
Display 9
Summary of Contents for SP 315-S
Page 2: ......
