1
2
3
0
<-
->
4
5
6
7
9
8
Edit
.
+++++++++++++++++++++++++++++++++
A
S
D
F
G
H
J
L
K
CapsLock
Q
W
E
R
T
Z
U
O
I
Edit
P
1
2
3
4
5
6
7
9
8
0
^
<----
Enter
Y
X
C
V
B
N
;
M
?
<--
-
.
-->
ATH-0023-UL776
SW026A
ASTNM+++++++++++
ABCD CORP.
Version April 2008
EN
13
agru SP 315-S User’s Manual
screen. Without a valid welder identification
code, it is impossible to start welding pro-
cesses on the machine, since the machine
is unblocked for operation only after a valid
welder identification code was entered.
Enter the welder identification code by
typing it on the touchscreen and saving it
to memory by touching the “Ok” button. If a
bar code for the welder code is available,
you can also read it from the bar code using
the scanning pen.
Info
All inputs for which a bar code is
available can be entered from the
bar code using a scanning pen.
Important
Entering data on the touchscreen must always be performed
with the bare finger. Using objects (ballpoint pens, screwdriv-
ers, etc.) may cause unrecoverable damage to the surface of
the touchscreen.
4.2
Entering Traceability Data for the Joint
After the welder identification code was entered, the traceability data for
the joint have to be entered.The machine
displays the traceability data for the last joint
that was welded (see Display 3), which can
be re-used for the next welding operation by
simply touching the “Ok” button.
If traceability data are not the same as for
the last joint, change the data that are dif-
ferent by touching the appropriate “Change”
button. Depending on the kind of data you
want to change, the machine displays either
a numeric keypad (see Display 2) or an
alphanumeric keyboard (see Display 4). To
confirm and save your data input to memory,
touch the “Ok” button.
Info
Depending on the software version
installed in your machine, some
screens may differ slightly on your
machine from the reproductions in
this manual.
When the traceability data were entered, the
machine displays the first input screen of the
welding process proper (see Display 5). In
this display, it is possible to start the welding
process and to customize the configuration
of the machine.
When going on from traceability data input
to the welding process proper or the input
of characteristic welding data, the machine
perform a calibration of the points of refer-
ence for its movable parts. Make sure this
short process is not interrupted.
Enter Welder Code
agru SP 315-S 26.04.08 14:54
+++++
Ok
Cancel
Display 2
Display 4
Enter Commission Number
Ok
Cancel
Commission No.
Welder Code
Additional Data/Addresses
Installing Company
Change
Change
Change
Change
agru SP 315-S 26.04.08 14:55
J.Doe
Last Traceability Data
Ok
Display 3
agru SP 315-S 26.04.08 14:55
+16°C
Summary of Contents for SP 315-S
Page 2: ......
