AGRU SP 315-S, User Manual

Page: 12 / 26

Version 1.55
Deutsch English
Español Français
Italiano Svenska
Simp. Chinese Trad. Chinese
Japanese Korean
Русский Č
eský
not defined not defined
Version April 2008 12
EN
agru SP 315-S User’s Manual
4 Operation
Important
Prior to the first use of the machine, the transport locks that
avoid longitudinal and transverse movement of the console
supporting the facing tool and the heating element have to be
removed (see photographs on page 9). An Allen wrench for
removing the transverse lock is included with the machine.
The control software of the machine monitors the transport
lock status. When the machine is turned on with the locks in
place, welding cannot be started and an
error message shows (see photograph on
this page).
Important
W h e n eve r t h e m a c h i n e i s m ove d , t h e
transport locks have first to be installed.
Damage due to the fact that the machine
was moved without installed transport locks
is not eligible for warranty. The transport lock
may be installed and removed only when
the machine is turned off. Damage due to
non-compliance with this provision will also
disqualify from warranty.
4.1 Check-out, Turning on, Selecting the Display Language
Place the machine on a level surface and ensure it cannot slide. Suffi-
cient distance has to be kept to other areas in the workshop, especially
to those in which combustible materials are used, in order for the heating
element temperature of up to 500°C (930°F) not to be hazardous.
Depending on the piece that is going to be welded, the outer clamps may
have to be repositioned or removed. To do so, loosen the locking bolts
and either remove the clamp or re-adjust it and secure it by tightening
the locking bolts again.
If the diameter of the pieces to be welded is smaller than the clamp, insert
the reducer inserts. This can be done with the enclosed Allen key.
Important
Pipe clamps and reducer inserts have to be clean or must be
cleaned before welding starts. To insert or remove the inserts,
do not use heavy tools (hammer, wrench). They may damage
the inserts.
Important
The surfaces of the heating plate have to be free of grease and
clean, or they have to be cleaned.
Important
Make sure all connectors are tight in their sockets and make
sure that the machine is operated
only if the conditions for safe and
intended use are met (see also
section 2).
After preparing the machine for welding and
connecting the power supply cord to the
mains power supply, the machine is turned
on using the On/Off switch. The welcome
screen, as reproduced in Display 1, appears
on the touchscreen panel. Touch the appro-
priate button to select the display language
that the machine will use.
After the language was selected, the ma-
chine takes the user to the welder code entry
Display 1