8
FIGURE 4
8. To prevent accidental tipping during the following
assembly procedures, lower the cart to rest upside
down, with the wheel support facing up, as shown in
figure 5.
9. Align the latch stand bracket so that the tab is at the
rear. Fasten the bracket to the rear set of holes at the
front of the cart using two 1/4" x 5/8" hex bolts, 1/4"
flat washers and 1/4" (SEMS) hex nuts. Use the 1/4"
flat washers as shims between the bracket and the
cart bed.
Make finger tight.
See figure 5.
FIGURE 6
11. Assemble a spacer tube onto each end of the axle as
shown in figure 7.
12. Assemble a 1" flat washer, a wheel (valve stem
facing out), and another 1" flat washer onto the axle
as shown in figure 7. Secure the wheel with a cotter
pin, spreading the ends so that a hub cap can fit over
the pin. Assemble the hub cap by pressing it onto the
flat washer. Repeat on other end of axle.
FIGURE 7
10. Position the rear tongue on the wheel support and
the latch stand bracket. Assemble the axle through
the wheel support and the tongue.
See figure 6.
IMPORTANT:
Make sure the tongue is securely locked
to the latch stand bracket by the latch lock lever.
7. Assemble the wheel support to the bottom of the cart
using eight 5/16" x 3/4" truss head bolts and 5/16"
(SEMS) hex nuts as shown in figure 4. Heads of bolts
go on the inside of cart.
Tighten.
LATCH STAND
BRACKET
(Tab at rear)
1/4" x 5/8"
HEX BOLT
1/4" (SEMS)
HEX NUT
1/4" FLAT
WASHER
AXLE
TONGUE
(REAR)
LATCH
LOCK
LEVER
COTTER PIN
WHEEL
HUB CAP
1" FLAT
WASHER
1" FLAT
WASHER
AXLE
SPACER TUBE
FIGURE 5
5/16" (SEMS)
HEX NUT
WHEEL
SUPPORT
5/16" x 3/4"
TRUSS HEAD BOLT
For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
