10
FIGURE 11
20. Place a side panel on top of the cart bed flange, inside
the lip of the front panel. Fasten the side panel to the
front panel using three 1/4" x 5/8" hex bolts, 1/4" lock
washers and 1/4" hex nuts. Fasten the side panel to
the cart bed flange using two 1/4" x 5/8" hex bolts,
1/4" flat washers, 1/4" lock washers and 1/4" hex
nuts.
Tighten.
See figure 11. Repeat on other side.
FIGURE 12
21. Screw a 1/4" hex nut approximately half an inch onto
a 1/4" x 1" hex bolt. Insert the bolt into the hole shown
in figure 12, in the side of the cart. Fasten the bolt to
the cart using a 1/4" lock washer and 1/4" hex nut.
Tighten
so that the nut is flush with the end of the
bolt. Repeat on the other side. See figure 12.
22. Assemble the cross brace to the top rear holes in the
side panels using four 1/4" x 5/8" hex bolts, 1/4" lock
washers and 1/4" hex nuts. See figure 12.
23. Assemble a door latch at each end of the cross brace
using a 5/16" x 3/4" hex bolt, a nylon washer and a
5/16" nylock nut. Place the nylon washer between the
door latch and cross brace.
Tighten
so that latch is
snug but will still rotate. See figure 13.
FIGURE 13
5/16" x 3/4"
HEX BOLT
CROSS
BRACE
DOOR
LATCH
NYLON
WASHER
5/16" NYLOCK NUT
24. Install the poly hard top using fourteen 1/4" x 3/4" hex
bolts and 1/4" flat washers on the outside and four-
teen 1/4" flat washers, 1/4" lock washers and 1/4" hex
nuts on the inside.
Tighten.
See figure 14.
FIGURE 14
1/4" x 5/8"
HEX BOLT
1/4" FLAT
WASHER
1/4" LOCK
WASHER
1/4" HEX NUT
1/4" HEX NUT
1/4" LOCK
WASHER
1/4" x 5/8"
HEX BOLT
1/4" x 3/4"
HEX BOLT
1/4" FLAT
WASHER
1/4" LOCK
WASHER
1/4" HEX NUT
POLY HARD TOP
1/4" FLAT
WASHER
1/4" HEX NUT
1/4" HEX NUT
1/4" x 5/8"
HEX BOLT
CROSS
BRACE
1/4" LOCK
WASHER
1/4" LOCK
WASHER
1/4" HEX NUT
1/4" x 1"
HEX BOLT
For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
