14
FIGURE 25
5. Holding the adapter bracket and the deck adapter
together, position the deck adapter on the mower
deck. Keeping the edge of deck adapter as close as
possible to the offset in the adapter bracket, see if
the slot in the adapter bracket can be aligned with
one or two of the deflector holes in your mower
deck's discharge opening. If the bracket can not be
located correctly using existing holes, it will be
necessary to drill one or two 5/16" diameter holes in
the deck. See figure 26.
4. Position the adapter over the deck opening, and
check for fit of cutout as shown in figure 25. Trim
cutout, if necessary, to allow tilting of adapter,
keeping the fit as close as possible for best vacuum
suction.
6. Assemble the adapter bracket to the deck using two
5/16" x 1" hex bolts, 5/16" flat washers and 5/16" lock
nuts. See figure 27.
NOTE:
It may be necessary to use extra 5/16" flat
washers to shim under the bracket next to the deck
surface. Ten extra washers have been furnished as
shims. See figure 27.
FIGURE 27
FIGURE 28
9. Assemble end of hose and a hose clamp over the
round opening of deck adapter and tighten clamp.
GO DIRECTLY TO THE OPERATION INSTRUC-
TIONS ON PAGE 16.
7. With deck adapter positioned correctly over the
discharge opening, use the adapter bracket as a
template and drill three 9/32" diameter holes in the
top of the deck adapter. See figure 28.
8. Bolt deck adapter to bracket using three 1/4" x 3/4"
bolts, nylon washers, 1/4" flat washers and 1/4" lock
nuts. Nylon washers should be against the inside of
the deck adapter. See figure 28.
FIGURE 26
MOWER DECK
DECK ADAPTER
NOTE: Make sure adapter clears gauge
wheels on mower deck
Curl on deck may be located outside of
adapter or inside depending on deck
opening design
DECK ADAPTER
MOWER DECK
ADAPTER BRACKET
Keep edge of adapter as close
as possible to offset in bracket
Use existing holes or drill 5/16"
diameter hole or holes.
ADAPTER BRACKET
5/16" flat washers
used as needed for
shims to adjust for
variations in decks.
(2) 5/16" LOCK NUTS
5/16" x 1" HEX BOLT
(2) 5/16" FLAT
WASHERS
(3) 1/4" HEX
LOCK NUTS
(3) NYLON
WASHERS
(3) 1/4" STEEL WASHERS
(3) 1/4" x 3/4" HEX BOLTS
ADAPTER
BRACKET
MOWER DECK
DECK ADAPTER
For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
