13
ASSEMBLING THE DECK ADAPTER
(#62468) TO THE MOWER DECK
Contents of Hardware Pack for Deck Adapter:
See Figure 23.
Key
Qty.
Description
A
2
Hex Bolt, 5/16" x 1"
B
3
Hex Bolt, 1/4" x 3/4"
C
2
Carriage Bolt, 5/16" x 3/4"
D
3
Hex Lock Nut, 5/16"
E
3
Hex Lock Nut, 1/4"
F
3
Flat Steel Washer, 1/4" Std.
G
12
Flat Washer, 5/16" Std.
H
3
Nylon Washer
I
1
Mounting Strap
J
1
Angle Bracket
K
1
Mounting Bracket
NOTE:
Not all of the hardware will be used for any one
particular fit up.
1. Remove the mower discharge deflector from your
mower deck. Save the deflector and hardware for
remounting.
IF YOU HAVE A MURRAY TRACTOR WITH A 38", 40"
OR 46" DECK, SKIP DIRECTLY TO PAGE 15.
2. Identify your mower deck (see fold outs) and cut out
the correct discharge opening template for your
mower deck size. If there is no template for your
deck size you can make your own template by
marking around a piece of cardboard held against the
edge of the discharge opening.
3. Tape the template to the face of the adapter, locating
template approximately 1/2" from front and 1/4" down
from top of adapter. Keep as close to top as possible.
See figure 24. Mark outline of template on face of
adapter using white crayon, nail or scriber. Drill a
starting hole inside the outline, then use a saber saw
or key hole saw to cut out the opening. See figure 24.
FIGURE 24
CAUTION:
Mower deflector must be
replaced when Mow-N-Vac deck adapter
is removed. Do Not operate mower
unless adapter or deflector is in place and
properly mounted.
FIGURE 23
1/4" DOWN
Keep cut-off as close to
the top edge as possible.
IMPORTANT:
1/2" FROM FRONT
I
J
K
A
B
C
E
D
H
G
F
NOT SHOWN FULL SIZE
SHOWN FULL SIZE
For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
