09
Similarly on the starboard side, fit the pivot pin
122-12
into the cog housing
122-11
. Make sure that the hole in
part
122-12
faces upwards (arrow). (The hull is viewed
from the other side to the previous step.)
Fit the end of the propeller shaft
120-02
into part
122-12
, with the flat side facing upwards. Fix in place
with a 2 x 3mm
PM
screw.
05
06
Take the shaft grip
B
from frame
122-13
and fit
it onto cog housing
122-11
. Fix it in place with two
2 x 4mm
PB
screws. The cog
122-09
and the cog
from
122-12
mesh with each other (arrow).
Fit the third pivot pin
122-12
on the third cog housing,
again with the hole facing upwards. Grip the end of
the central shaft
121-02
so that the flat side faces
upwards (arrow).
10
Fit the end of the propeller shaft
121-02
into the
opening in part
122-12
. Fix in place with a 2 x 3mm
PM
screw.
Fit the grip
D
from frame
122-13
over the pivot pin.
Fix it to the connector
111-02
with two 2 x 4mm
PM
screws. After fitting, check that the propellers can
rotate freely.
07
08
120-02
121-02
122-12
111-02
122-11
122-12
122-12
B
122-11
122-11
C
121-02
122-12
C
D
PM
2 x 3
PB
2 x 4
PM
2 x 3
PM
2 x 4
23
23
AGORA
MODELS
24
AGORA
MODELS
