Agilent Technologies N6700B, User Manual

Page: 18 / 206

2 Installation
18 Series N6700 User’s Guide
The Agilent N6700 MPS can be mounted in a 19-inch EIA rack
cabinet. It is designed to fit in one rack unit (1U) of space. Install the
rack mount kit as shown in the following figure.
Step 1. Install eight clip-nuts on the rack frame (2 in each corner) where
your instrument will be located
Step 2. Install the two front ears and the two rear extender supports on the
instrument as shown in the figure. Use six M3 x 8mm screws (a) for
the front ears and four M3 x 6mm screws (b) for the extender
supports. If the standard extender supports are either too short or
too long, use the longer supports (c). Cut the supports if required (d).
Step 3. Install the two rear ears on the back of the instrument rack as shown
in the figure. Use the four plain 10-32 screws to install the rear ears.
Step 4. Slide the instrument into the rack, making sure that the rear
extender supports are aligned inside the rear ears.
Step 5. Attach the front ears to the front of the instrument rack using the
four dress 10-32 screws provided.
Step 6. This is optional. Insert a plain 10-32 screw through the slot of the
rear ear and extender support. Attach it with a clip-nut. Note that
this will prevent the unit from being slid out of the front of the rack.
2a
3
4
5
6
1
2b
2c
2d
1