Agilent Technologies G4782A, User Manual

Page: 175 / 202

1260 SFC Binary Pump 175
LAN Configuration
12
TCP/IP parameter configuration
TCP/IP parameter configuration
To operate properly in a network environment, the LAN interface must be
configured with valid TCP/IP network parameters. These parameters are:
•
IP address
• Subnet Mask
•
Default Gateway
The TCP/IP parameters can be configured by the following methods:
• by automatically requesting the parameters from a network-based DHCP
Server (using the so-called Dynamic Host Configuration Protocol). This
mode requires a LAN-onboard Module or a G1369C LAN Interface card, see
“Setup (DHCP)” on page 180
•
by manually setting the parameters using Telnet
•
by manually setting the parameters using the Instant Pilot (G4208A)
The LAN interface differentiates between several initialization modes. The
initialization mode (short form ‘init mode’) defines how to determine the
active TCP/IP parameters after power-on. The parameters may be derived
non-volatile memory or initialized with known default values. The
initialization mode is selected by the configuration switch, see
Table 16 on
page 177.