Agilent Technologies 85052C, User'S And Service Manual

Page: 28 / 62

3-10 85052C
Use, Maintenance, and Care of the Devices
Gaging Connectors
Gaging Female 3.5 mm Connectors
NOTE Always hold a connector gage by the gage barrel, below the dial indicator.
This gives the best stability, and improves measurement accuracy. (Cradling
the gage in your hand or holding it by the dial applies stress to the gage
plunger mechanism through the dial indicator housing.)
1. Select the proper gage for your connector. Refer to Table 6-2 on page 6-3 for gage part
numbers.
2. Inspect and clean the gage, gage master, and device to be gaged. Refer to “Visual
Inspection” and “Cleaning Connectors” earlier in this chapter.
3. Zero the connector gage (refer to Figure 3-3 ):
a. While holding the gage by the barrel, and without turning the gage or the device,
screw the female gage connecting nut onto the female gage master, just until you
meet resistance. Connect the nut finger-tight. Do not overtighten.
b. Using an open-end wrench to keep the gage master from rotating, use the torque
wrench recommended for use with the kit to tighten the connecting nut to the
specified torque. Refer to
“Final Connection Using a Torque Wrench” on page 3-12 for
additional information.
c. As you watch the gage pointer, gently tap the barrel of the gage to settle the reading.
The gage pointer should line up exactly with the zero mark on the gage. If not, adjust
the zero set knob until the gage pointer lines up exactly with zero.
d. Remove the gage master.
4. Gage the device connector (refer to Figure 3-3 ):
a. While holding the gage by the barrel, and without turning the gage or the device,
screw the female gage connecting nut onto the female device being measured, just
until you meet resistance. Connect the nut finger-tight. Do not overtighten.
b. Using an open-end wrench to keep the gage master from rotating, use the torque
wrench recommended for use with the kit to tighten the connecting nut to the
specified torque. Refer to
“Final Connection Using a Torque Wrench” on page 3-12 for
additional information.
c. Gently tap the barrel of the gage with your finger to settle the gage reading.
d. Read the gage indicator dial. Read only the black
±
signs; not the red
±
signs.
For maximum accuracy, measure the connector a minimum of three times and take
an average of the readings. Use different orientations of the gage within the
connector. After each measurement, rotate the gage a quarter-turn to reduce
measurement variations that result from the gage or the connector face not being
exactly perpendicular to the center axis.
e. Compare the average reading with the observed pin depth limits in Table 2-2 on page
2-4 .