Agilent Technologies 16451B, Operation Manual

Page: 112 / 149

Micrometer Stand Replacement
When replacing the micrometer stand, press it against the slide stand
assembly's guide and align the back edge of the micrometer stand and
the slide stand assembly , as shown in Figure 4-2.
Figure 4-2. Micrometer Stand Replacement
Micrometer Replacement
When replacing the micrometer , put the micrometer completely into
the micrometer stand and turn the ne scale adjustment line until it is
facing vertical, as shown in Figure 4-3. Then tighten the micrometer
stand's set screw to rmly attach the micrometer to the stand. The
proper tightening torque is 3 kgf/cm. (About 3 kgf/cm may be applied
to the screw when the furnished hex key is used.) If the screw is
tighten too much, the micrometer will not function smoothly .
Figure 4-3. Micrometer Replacement
4-2 Service