AGFA W Class, Operator'S Manual

Page: 90 / 132

80 W-Class
Printer Fault Messages (continued)
Displayed Message Description Possible Solution(s)
!
!
ENB!GBVMU!
The printer has
detected a Direct
Memory Access
failure. Try cycling the printer power
‘Off’ and ‘On’. If the fault
does not clear, call for
service.
!
HBQ!NPEF!
DBOOPU!DBMJCSBUF!
!
Consistently low
sensor readings
were detected. Press any key to continue.
Ensure that media was
inserted in the media sensor
during the appropriate
calibration step; also ensure
that the sensor is free of
debris. Retry the calibration.
If the problem persists, try the
‘Advanced Entry
Calibration’; see Section
5.0.2.
!
HBQ!NPEF!
GBVMUZ!TFOTPS!
!
Consistently high
sensor readings
were detected.
Press any key to continue.
Ensure that media was
removed from the media
sensor during the appropriate
calibration steps; also ensure
that no labels are stuck in the
media sensor. Retry the
calibration. If the problem
persists, call for service.
!
!
PVU!PG!TUPDL!
!
The printer cannot
detect media. Try the following:
1) Load media.
2) Ensure that the labels are
passing through the Media
Sensor.
3) Readjust the Media Sensor
over the TOF mark; see
Section 3.2.
4) If using media with large
gaps, adjust the Paper Out
Distance; see Section 4.1.2.
5) Calibrate the printer; see
Section 5.0.