AGFA W Class, Operator'S Manual

Page: 24 / 132

14 W-Class
3.1.2 Fan-Fold Media
This loading method is for tag and fan-fold type media applications. To load:
Bring media in from the Bottom or
Rear Fan-Fold Slot and through the
printer, as shown below. (If using
reflective stock, ensure that the mark is
facedown.)
Slide the Media Guide over until it
rests lightly against the edge of the
media.
With the Roller Lever in its ‘down’
position, slide the Fan-Fold Media
Guide onto the Media Supply Hub and
route the media through the slot in the guide. Ensure the media rests against
the Backstop, then raise the Roller Lever to its ‘up’ position and tighten the
Thumbscrew on the bottom of the Fan-Fold Media Guide.
Position the Media Sensor; see Section 3.2.
If your application uses thermal transfer media, load ribbon (see Section
3.3); otherwise continue.
Lower the printhead assembly and rotate the Printhead Latch back into the
locked position. Close the Access Cover.
Turn ‘On’ the printer. After ‘Ready is displayed, press and hold the FEED
key until at least one label gap or mark is advanced; see Section 3.4.
If using less than full width media, adjust the Leveling Cam; see Section
5.1.1.