Electrical Connection
The module comes with a 3-prong power supply cord. It
must be plugged into a mating 115 volt, 60 Hz, 15 amp
separately fused, 3-prong grounded outlet serving only
this product, and wired in accordance with National and
Local Electrical Codes and ordinances. A time delay fuse or
circuit breaker is recommended. DO NOT USE AN EXTEN
-
SION CORD OR ADAPTER PLUG.
DO NOT REMOVE THE GROUND PRONG FROM THE
POWER SUPPLY CORD UNDER ANY CIRCUMSTANCES!
If voltage varies by 10 percent or more, performance of
your refrigerator/freezer may be affected. Operating the
refrigerator/freezer with insufficient voltage can damage
the compressor. Such damage is not covered under your
warranty. If you suspect your voltage is high or low, con
-
sult your power company for testing.
Do NOT pinch, knot, or bend the power cord in any man
-
ner.
NEVER unplug the refrigerator/freezer by pulling on the
power cord. Always grip the plug firmly and pull straight
out from the receptacle. To avoid electrical shock, unplug
the refrigerator/freezer before cleaning and before replac
-
ing a light bulb.
NOTE:
Turning the control to “OFF” turns off the compres
-
sor, but does not disconnect power to the light bulb or
other electrical components. The unit MUST be unplugged
or turned off at the circuit breaker.
INSTALLATION
3
Select Location
Locate the refrigerator/freezer in the coolest part of the
room, out of direct sunlight and away from heating ducts
or registers.
Do not place the refrigerator/freezer next to heat-produc
-
ing appliances such as a range, oven or dishwasher. If this
is not possible, a section of cabinetry or an added layer
of insulation between the two (2) appliances will help the
refrigerator/freezer operate more efficiently.
IMPORTANT
When installing the water line for the ice maker, be sure to
install a SHUT-OFF VALVE at a convenient location between
the refrigerator and the supply line.
Required water pressure range is 20 to 120 psi.
Also required is an in-line WATER FILTER between the
refrigerator and the supply line to prevent sediment from
blocking water flow through the water solenoid valve.
NOTE:
Self-piercing water valves and plastic tubing are
NOT
approved for water supply to ice maker.
