AGA marvel 18AF, Installation & Operation Manual

Page: 4 / 32

PRE-INSTALLATION
2
Floor under product MUST be at or above the same level as the surrounding FINISHED floor, for ease of installation and
removal.
Electrical: Provide 115 Volt, 60 Cycle, Single Phase, 15 Amp, AC Receptacle. It is recommended that a separate circuit, serv -
ing only this appliance, be provided. *Two (2) units side-by-side require separate circuits, except the 60SS and 72SS (see
Instruction Sheet 34361-000). Electrical opening should be placed 78 1/2 inches minimum from the floor.
Plumbing: Ice maker water supply line (1/4 inch OD copper tubing) to come up the rear of cut-out opening approximately
78 inches off the floor depending on height adjustment. Tubing should then pass around the right side of the module and
around the front to the solenoid valve (see Installation Instructions provided with the unit).
Cut-Out Detail for 1 Unit
Cut-Out Width = “A”
*Cut-Out Detail for 2 Units
Placed Side by Side
Cut-Out Width = “A” + “A” + 1/2”
Model
Cut-Out Width
(inches)
18AR 17 1/2
18AF 17 1/2
18TF 17 1/2
18WC 17 1/2
24AR 23 1/2
24AF 23 1/2
24TF 23 1/2
24WC 23 1/2
24BC 23 1/2
242Z 23 1/2
30AR 29 1/2
30AF 29 1/2
30TF 29 1/2
36AR 35 1/2
36AF 35 1/2
36TF 35 1/2
36SS 35 1/2
363D 35 1/2
42SS 41 1/2
48SS 47 1/2
54SS 53 1/2
60SS 59 1/2
66SS 65 1/2
72SS 71 1/2
NOTE: Allow for three (3) inch high removable filler panel for easy removal of power module.
Receptacle must be placed in
this location for 18” models.
22”
22”
Ice Maker
Tubing
20”
Min. (typ)
*See note below.
A A
A
83 3/4”
to
84 1/2”
24”
24”
78”
approx.
78 1/2”
Min.
(typ)
1/2”
83 3/4”
to
84 1/2”