INSTALLING THE SIDE PANELS AND KICK PLATE
11
Instructions for Fastening Side Panels to Refrig-
erator
1. Side panels should be 24 inches D (or 24 5/16
inches D when tucked into the front trim).
2. Panel height to match installation height.
3. Install the side panels per drawings on the
right.
NOTE:
To avoid damage to panels or flooring,
raise panels slightly, to clear floor when installing.
Drill three (3) holes equal distance apart in verti
-
cal section of aluminum frame and install pan
head screws as shown.
Anchor side panel with screw as shown. Be sure
screw used goes no more than 1/2 inch deep into
product. Do NOT overtighten.
Kick Plate Installation
Use two (2) #8 sheet metal screws to facilitate holding your kick plate in place. Mount screws in holes in roller base. Notch
-
ing of upper corners may be required to clear hinges.
Typical Side Panel Installations
Measure the distance between
mounting holes on roller base.
#8 Sheet
Metal Screw
Drill three (3) holes equal distance apart in vertical section of aluminum frame and install # 6 - 3/8 pan head screws as
shown (provided).
Attach side panel to cabinet with screws as shown. Screws must not penetrate cabinet more than 1/2 inch.
24”
“D”
“A”
“B”
“C”
Typ.
1 1/8”
1/4” Thick Battens
3/16” Thick Back Up
1/4” Plywood/Panel
3/16” Thick Battens
1/4” Plywood/Panel
1/8” Thick Back Up
24 5/16”
1/16” Rout
1/2” Plywood/Panel
2 3/16”
11/32”
5/16”
Metal Side Panel
(Typ. Installation Opening)
