HINGE AND GASKET ADJUSTMENTS AND FACE MOUNTED DOOR HANDLES
10
Hinge and Gasket Adjustment
It is possible that doors may become out of adjustment in
shipment. See diagram on right.
If product is installed slightly “out of level”, doors may not
line up properly. Check this BEFORE adjusting hinges.
NOTE:
Door gaskets occasionally compress in shipment. If
gasket does not seal all around, warm slightly with a hair
dryer and pull outward softly until magnet in gasket seals
against cabinet.
Change or Tighten Face Mounted Door Handles
1. Open the door - remove the interior door shelves.
2. Remove the screws that secure the shelf mounting rail
and the rail.
3. Remove the plug buttons (exposing handle screws) -
make sure not to scratch the inner liner.
4. Remove the foam insert to expose the door handle
mounting screw.
5. Change handle/tighten screw and replace foam insert,
plug button, shelf rail and door shelf.
Stainless Steel Wrap Door Units
To expose concealed door hinge screws, remove plug
buttons if present. All hinge sections attached to doors
adjust left or right. Top and bottom cabinet hinges are
also adjustable in and out. See diagram (shown without
cabinet trim).
Panel Ready Doors
To expose the concealed door screws, first remove handle trim. Then slide trim over hinge toward handle side. If your unit
requires door panels, see “Custom Door Panel” section, on page 14.
All hinge sections attached to doors, adjust left or right. Top and bottom cabinet hinges are also adjustable in and out.
Adjustable Screws
Edge of Door Trim
Door
Cabine
t
Cabinet
Adjustable
Screws
Door
Foam
Shelf Mounting
Rail and Screw
Door Shelf
Plug Button
Handle Mounting
Screw
Foam Insert
Door Handle
