ERROR CODES
November 29, 1999
7-34
Code
Meaning
Suggested Cause/Action
9-40
CRC error while receiving
a frame
Check and adjust the host PC's RS232C port
settings.
9-41
Command 3rd try failed
Check if a proper cable is used and connected
9-42
DCN received
unexpectedly
securely.
Check if the application is working correctly.
9-43
Unexpected frame
received
If the problem persists, replace the FCU.
9-44
Response time over
Note: The optional PC fax expander may not be
9-45
Frame transmission error
available in some countries.
9-50
Paper non-feed or jam
inside the upper paper
feed unit
Check if a recommended type of paper is used.
Check if the paper guides are aligned to the paper
correctly.
Check the paper feed mechanism in the unit.
9-51
Jam at the paper exit of the
upper paper feed unit.
Check for a blockage in the paper feed path.
Check the paper feed mechanisms inside the unit.
Check if the sensor is defective.
9-52
Paper non-feed or jam
inside the lower paper feed
unit
Check if a recommended type of paper is used.
Check if the paper guides are aligned to the paper
correctly.
Check the paper feed mechanism in the unit.
9-53
Jam at the paper exit from
the lower paper feed unit.
Check for a blockage in the paper feed path.
Check the paper feed mechanisms inside the unit.
Check if the sensor is defective.
9-80
Bypass feed - paper non-
feed or jam at the entrance
Check the registration roller and sensor.
9-81
Bypass feed - paper length
exceeds the maximum limit
(600 mm)
Check the paper feed mechanism and sensors.
9-84
Paper non-feed or jam at
the cassette entrance
Same as 9-07
10-**
Refer to the optional NIC
fax board manual.