BIT SWITCHES
November 29, 1999
4-48
Communication Switch 14
No
FUNCTION
COMMENTS
0
Inch-to-mm conversion
during transmission
0: Disabled (default)
1: Enabled
0: Transmitting is always done in inch format.
1: If the other end only has mm-based resolution
for printing, the machine converts the scanned
data to mm-format before transmission.
1
Inch/mm format informed to
the other terminal during
transmission
0: Always in inch format
1: Dependent on the other
terminal (default)
0: The machine always informs the other terminal
that the resolution is in inch format and transmits
with the inch format.
1: The machine informs the other terminal that the
resolution is in mm format and transmits with the
inch format if the other end only has mm-based
resolution.
This setting is informed to the receiving terminal
in the pre-message protocol exchange (in the
DCS/NSS frames).
2-4
Not used
Do not change the factory settings.
5
A3 size reception
0: Enabled
1: Disabled (Max. B4 size)
1: The machine informs the other terminal that the
maximum width is B4 size.
6
7
Available unit of resolution in
which fax messages are
received
Bit 7
Bit 6
Unit
0
0
mm
0
1
inch
1
0
mm and inch
(default)
1
1
Not used
For the best performance, do not change the
factory settings.
The setting determined by these bits is informed
to the transmitting terminal in the pre-message
protocol exchange (in the DIS/NSF frames).
Communication Switch 15
No
FUNCTION
COMMENTS
0
to
7
Available resolution for
receiving fax messages
Bit 0 1: 200 x 100/8 x 3.85
Bit 1 1: 200 x 200/8 x 7.7
Other bits: Not used
For the best performance, do not change the
factory settings.
The setting determined by these bits is informed
to the transmitting terminal in the pre-message
protocol exchange (in the DIS/NSF frames).
