Aficio 2404WD, Operating Instructions Manual

Page: 17 / 92

When You Have Problems Operating the Machine
11
1
Original images are
printed on the reverse
side of the paper. You may have loaded
the paper incorrectly. Load paper correctly. Load paper into
the cut paper tray print side down, and
into the bypass tray print side up. See
p.57 “Loading Paper”.
Misfeeds occur frequently. The cut paper tray's side
fences, back fence, or
side-end fences, might
not be set properly.
• Remove the paper. See p.67 “Remov-
ing Jammed Paper”.
• Check the side fences, back fence,
and side-end fences are set properly.
See p.61 “Changing the Paper Size”.
Misfeeds occur frequently. Paper is wrinkled or
folded.
Cut folded or wrinkled areas off the pa-
per roll.
Remove cut paper that is folded or wrinkled.
Misfeeds occur frequently. Jammed or torn paper is
inside the machine.
Remove the paper, as necessary. See
p.67 “Removing Jammed Paper”.
Misfeeds occur frequently. You may have loaded pa-
per of a size different from
the paper size settings.
• Remove the paper. See p.67 “Remov-
ing Jammed Paper”.
• Use Tray Paper Size Settings to set
the paper size. See “Tray Paper Set-
tings”, General Settings Guide and
“Copy Paper”, About This Machine.
An error C message re-
mains, even if misfed pa-
per is removed. You did not open and
close the upper section of
the fusing unit. When a misfeed C message appears, it
remains until you open and close the
upper section of the fusing unit. Open
the fusing unit cover in the back, and
then the upper section of the fusing unit
to check if any paper remains inside. See
p.67 “Removing Jammed Paper”.
Originals jam frequently. Originals are curled. Smooth out any curls and try again.
Problem Cause Solution