![background image](http://html.mh-extra.com/html/afe-power/77-83046/77-83046_instruction-manual_2864078016.webp)
Page 16
Refer to Figure M for Steps 23-26 (Installation for Ranger Only)
Step 23: Locate the T-MAP sensor jumper harness on the aFe POWER harness. It is the longer, second set
of connectors coming out of the aFe POWER module. It
is labeled “T-MAP”.
Step 24: Plug the female connector of the aFe POWER harness to the T-MAP sensor, then take the male
connector of the aFe POWER harness and connect it to the female connector of the engine harness.
Step 25: Check with the picture to make sure the connectors are fully seated and that the locking tab is slid
back into place.
Step 26:
Reinstall the radiator dust cover and push clips.
Make sure that the connections are fully engaged and not reversed. Usually, connectors make a
snapping sound when fully engaged.
INSTALL
Figure M
T-MAP Sensor Connectors