![background image](http://html.mh-extra.com/html/afe-power/77-83046/77-83046_instruction-manual_2864078004.webp)
Page 4
Refer to Figure A for Step 1 (For both Bronco and Ranger)
Step 1: Before installing your aFe POWER
module, you will have to place your vehicle’s ECU in sleep
mode. In order to do this, you will need to do the following:
•
If the engine is cold: open the hood, close the doors, lock the car and wait 30 seconds.
•
If the engine is warm: open the hood, close the doors, lock the car and wait 20 minutes.
•
If the engine is warm and you can’t wait 20 minutes: disconnect the battery.
Note: Do NOT open doors or start vehicle while one of the sensors is disconnected. This
could create a check engine light
2
1
REMOVAL
Figure A