Page 14
Refer to Figure K for Steps 18-20 (Installation for Ranger Only)
Step 18: Locate the MAP sensor jumper harness on the aFe POWER harness. It is the first, shorter set of
connectors coming out of the aFe POWER module. It is
labeled “MAP”.
Step 19: Plug the female connector of the aFe POWER harness to the MAP sensor, then take the male
connector of the aFe POWER harness and connect it to the female connector of the engine harness.
Step 20: Check with the picture to make sure the connectors are fully seated and that the locking tab is slid
back into place.
Make sure that the connections are fully engaged and not reversed. Usually, connectors make a
snapping sound when fully engaged.
INSTALL
Figure K
MAP Sensor Connectors