Page 10
Refer to Figure G for Steps 11-13 (Installation for Bronco Only)
Step 11: Locate the T-MAP sensor jumper harness on the aFe POWER harness. It is the longer, second set
of connectors coming out of the aFe POWER module. It
is labeled “T-MAP”.
Step 12: Plug the female connector of the aFe POWER harness to the T-MAP sensor, then take the male
connector of the aFe POWER harness and connect it to the female connector of the engine harness.
Step 13: Check with the picture to make sure the connectors are fully seated and that the locking tab is slid
back into place.
Make sure that the connections are fully engaged and not reversed. Usually, connectors make a
snapping sound when fully engaged.
Go to Page 17 for the next step on the Bronco installation
INSTALL
Figure G
T-MAP Sensor Connectors