Safety instructions
Assembly instructions EN
SE20 - SE30
Date 06.09.2021
Version 2.0
13–56
2.8 General hazards / residual risks
Despite the safe design of the rotational axis and the technical protective
measures taken, there remain residual risks that cannot be avoided, and which
present a non-obvious residual risk when operating the module.
Observe the safety instructions in this chapter and in the other sections of this
manual to avoid damage to property and dangerous situations for the personnel.
2.8.1 General hazards at the workplace
The rotational axis has been built according to the state-of-the-art and the
applicable health and safety requirements. However, improper use of the
rotational axis may cause the following hazards to the personnel:
danger to life and limb of the operator or third parties,
on the rotational axes themselves,
property damage.
Always keep the assembly instructions ready at hand at the workplace!
Furthermore, the following apply:
the general and local regulations on accident prevention and environmental
protection,
the safety information sheet for the rotational axis.
WARNING
Danger - Do not use in unsuitable environment!
The rotational axes are designed for use in
non
explosive atmospheres.
Do
not
use the modules in potentially explosive atmospheres!
WARNING
Risk of injuries due to uncontrolled parts movements!
When connecting and operating the rotational axes, unexpected movements
can lead to serious injuries and/or damage to property.
Only qualified personnel may work with or on the rotational axis.
CAUTION
Risk of injury due to high noise exposure!
The noise level of the rotational axis at full load operation is below 78 dB(A).
Depending on the add-ons, the environment and the resonance of the
protective device theses values may be exceeded and expose the operator
to a higher noise level.
The operating company is responsible for ensuring that the permissible
noise levels are observed.
Summary of Contents for SE20
Page 53: ...Assembly instructions EN SE20 SE30 Date 06 09 2021 Version 2 0 53 56 ...
Page 54: ...54 56 Assembly instructions EN SE20 SE30 Date 06 09 2021 Version 2 0 ...
Page 55: ...Assembly instructions EN SE20 SE30 Date 06 09 2021 Version 2 0 55 56 ...
Page 56: ...56 56 Assembly instructions EN SE20 SE30 Date 06 09 2021 Version 2 0 ...