56
13. Once satisfied with fit. Align template with the
center mark on cowl and fit flush with rear of
cowl. Tape template to bottom of cowling and
mark cut lines with removable marker.
Note:
Take care and test painted areas prior to
using any type of paint remover, rubbing
alcohols or cleaners to remove any pen lines.
14. Remove the template and use a rotary cutting
tool and sanding drum to cut out the opening in
the cowl.
15. Reinstall the cowl to check the fit of the cylinder
head and muffler.
Note:
Be sure that the cylinder head and muffler
will not rub against the cowl. Make
adjustments as necessary.
Note:
We have found this to be adequate cooling for
the DA 50. Depending on your engine’s oper-
ating temperature, you may need to allow for
more exit air for your engine to run at its rec-
ommended operating temperature.
Always check the operating temperature of
your engine to prevent any damage from
occurring. Aeroworks is not responsible for
damages incurred from improper engine
cooling.
16.
Finished cowl installation shown below.
