20
4. Install the control horns using the same method
described for the wings.
3. Correct installation of ball link, flat washer and
brass spacer to servo arm shown below.
5. Use tape to hold elevator in the neutral position.
Plug the servo into the receiver and turn radio
on. Ensure the servo trim and sub trim is cen-
tered. Adjust the length of the pushrod so that
the servo arm is parallel to the elevator hinge
line when it is placed on the servo output shaft.
Screw servo arm on the servo output shaft.
Note:
On metal geared servos use Loctite for all
Servo arm mounting screws.
