52
5. Final radio installation shown below.
6. Push receiver antenna all the way into the pre
installed receiver antenna guide tube.
Note:
Apply baby powder or corn starch to antenna
wire to assist getting antenna into their guide
tubes.
7. Tape the receiver antenna wire to the end of the
antenna guide tube and to the radio floor as
shown. This will prevent the antenna wire from
vibrating back out.
8. Install a Y Harness into the aileron ports of the
receiver, connect one side of the Y harness to the
extension for the upper wing. Use an
Aeroworks
safety clip
. Ensure the plugs will not come apart
from vibration or light tension.
