19
STAB AND ELEVATOR ASSEMBLY
Elevator Servo Installation
1. The elevators have been pre-hinged and
glued
to
the stabs and are ready for flight. No other steps
are necessary for hinging. Clear covering has
been provided for sealing of the hinge gaps if
desired.
Gather the stabs and elevators, one eleva-
tor servos, and 36” servo extensions.
Note:
36” servo extension will be used to
connect servos to receiver during a later
step.
2. Install servo in servo well with the output shaft
toward the leading edge of the stab. Fish the
servo lead through the stab and out of the stab
root rib.
1. Gather the elevator control linkage parts as
shown below. There are (2) 4-40 pushrods, (4)
4-40 ball link assemblies, (2) Flat washers
(2)
brass spacers, (2) left and (2) right side control
horns, (1) Adjustment wrench and (12) wood
screws.
Elevator Control Linkage Installation
2. Assemble the pushrod and control horn assem-
bly as shown. The ball link goes between the
left and right sides of the control horn sides and
is secured with a nylon lock nut.
