15
Aileron Control Linkage
Installation
1. Gather the aileron and control linkage parts as
shown below.
◊
2 - 3” pushrod
◊
4 - 4-40 ball link assemblies
◊
2 - Brass spacers
◊
2 - Flat washer
◊
2 - Left control horns
◊
2 - Right control horns
◊
12 - Wood screws for each wing panel
◊
1 - Adjustment wrench
8.
Finished servo installation shown below.
2.
Assemble two pushrod and control horn
assemblies as shown. The ball link goes
between the left and right sides of the control horn
sides and is secured with a nylon lock nut.
IMPORTANT
: The ball link for the root end
control horn goes in the bottom hole of the horn.
The ball link for the tip end horn goes in the mid-
dle hole of the horn. This gives the correct offset
to eliminate binding and twisting of the aileron.
Note:
It will still be necessary to either program or
use a after market type
Match Box
system to as-
sure your servos will not bind or fight against
each other.
Tip end
Middle hole
Root end
Bottom hole
3. Correct installation of ball link, flat washer and
brass spacer to servo arm shown below.
Note:
Flat washer prevents ball link from
coming off brass ball.
