24
3.4.3
Configuring the Recording Duration
1.
In the OFF position, hold the
(yellow) button down while turning
the switch to
, until the end of the "full screen" display and the
emission of a beep, to enter the configuration mode. The display will
then indicate the recording interval.
NOTE:
The default value is 60 seconds. Possible values range from 1 second to
600 seconds (10 minutes).
2.
To change the recording interval, press the
(yellow) button. The
right-hand digit blinks. Each press on the
(yellow) button
increments its value. To go to the next digit, apply a long press (>2s) to
the
(yellow) button.
3.
When the desired unit is displayed, turn the switch to another setting.
The unit chosen is stored and a double beep is emitted.
3.4.4
Erasing Recordings from Memory
To erase a recording from memory, perform the following:
NOTE:
Make sure there is no voltage on the input terminals.
1.
In the OFF position, hold the
(yellow) button down while turning the
switch to
.
2.
The device emits a beep after erasing the records in memory. The "
rSt
"
and "
rEC
" symbols are displayed.
3.
The device then switches to normal continuity measurement.
3.4.5
Default Configuration
To reset the clamp-on meter to its default parameters (factory configuration):
1.
In the OFF position, hold the
(yellow) button down while turning the
switch to
, until the "full screen" display ends and a beep is emitted.
The
"rSt"
symbol is displayed.
2.
After 2 s, the clamp-on meter emits a double beep, then all of the digital
symbols of the screen are displayed until the
(yellow) button is
released. The default parameters are then restored:
Recording interval = 60 seconds
Continuity detection threshold = 40
True InRush triggering threshold = 10%
Summary of Contents for 407
Page 1: ... 32 5 03 21 0 7 5 8VHU 0DQXDO 1 6 ...
Page 2: ... ...
Page 47: ...47 4 In the Bluetooth Devices window select Add ...
Page 83: ......
