DURESS CODES (FOR OUTPUTS 1 & 2) (Locations 41 & 42)
Duress Codes are prepared for those
Important Persons
in case of
DURESS
while he is operating
the access control keypad. The duress code operates like a normal User Code for Output 1 or 2, and
at the same time activates the Duress Output without any indication. The user may use it to report
an emergency and ask for help silently when he is forced to operate the keypad if the Duress
Output is connected with a security system (for example, an Auto-dialer).
NOTE:
The Duress Codes are always valid. They are not governed by any inhibit or lockup function
in the system.
(1) LOCATIONS
–
Duress Codes for Output 1
–
Duress Codes for Output 2
(2) DURESS CODE IDs
- 50 Duress Code IDs for The Output 1
- 10 Duress Code IDs for The Output 2
=
Clear all the Duress Codes from the selected Location group
.
Please see the programming example below for the details.
(3) THE DURESS CODES
50 and 10 Duress Codes can be programmed for Output 1 and 2 respectively. They are stored in
their two-digit Code ID box. When a new Code is put into the same Code ID box, the old code is
replaced.
(4) VALIDATION
Press key once. Two-beep confirms the entry.
27
The Duress Codes are 4-8 digits for Manual Mode code entry.
The Duress Codes MUST be in the same digit length with the Master Code for Auto Mode
code entry.
Always set a Duress Code that is easy to remember in Panic Situation. Only one number
different from the daily used User Code is highly recommended.
Example:
User Code is
1 3 6 9
,
then
3 3 6 9
or
1 3 6 0
might be a good choice for the
Duress Code.
The
Duress Code
can also be used to
replace the Secondary User Code or Common
User Code
in Card reading for the Duress reporting.
-
4-8 DIGITS
DURESS CODE
VALIDATION
-
LOCATIONS
CODE ID
(4)
(3)
(2)
(1)
34
PERSONAL SAFETY AND SYSTEM LOCK-UP (Location 60)
(1) LOCATION
Key in Location
(2) LOCK-UP OPTIONS
The Options are represented by the following Numbers. They are described below:
--- After 10 successive false Card/User Code trials, the keypad locks during 60 seconds.
--- After 10 successive false Card/User Code trials, activates the Duress output to switch to (-)
-
--- Selection of after 5 to 10 successive Card/User Code trials, the keypad locks during
Example:
Release the lock-up --
--- Disappearance of all the above lock-up securities.
(3) VALIDATION
Press key once. Two-beep confirms the entry
SUPER USER CODE
1 to 2 Digits
LOCK-UP OPTIONS
VALIDATION
LOCATION
(3)
(2)
(1)
-- (Default)
ground.The Duress Output can be released with any user Code or Card in the User Group 1
or Super User Code.
15 minutes. The keypad can be reset to release the lock-up with the “Super User
Code” in the following way.
