19
42
OPERATION MODES (Location 94)
The keypad is programmable for keypad mode to work stand-alone for door control directly or for
server mode to work with a split-decoder for high security access control.
LOCATION OPERATION MODES VALIDATION
(1) LOCATION
Key in Location
(2) OPERATION MODES
– Keypad Mode (Default)
Keypad Mode sets the keypad for stand-alone operation to provide its available functions. It is
compatible with the auxiliary readers/keypads for multi-station expansion.
– Server Mode
Server Mode sets the keypad to compatible with both the decoder for split-decoded operation and
the auxiliary readers/keypads for multi-station expansion. A split decoded keypad system uses the
keypad(s) for human interface outside and the internal decoder for door lock control to prevent
sabotage.
(3) VALIDATION
Press key once. Two-beep confirms the entry
or
(3)
(2)
(1)
CLOSE PROGRAMMING MODE ( * * )
Always close programming mode with * * to set system back to normal Operation after
programming.
The button is equivalent to the button in the keypad with bell button.
VALIDATION
------------------------------- System is back to normal operation mode
3) Pause The Scheduled Daily Inhibition for Output 1 (Temporarily Disable The Inhibition)
The scheduled inhibition can be programmed and applied to Output 1 with daily start and stop times.
It can be stopped temporarily if required; such as the staff work overtime after office hours going
into the inhibition period. This function Starts / Stops in toggle with the following code entry. It can
be done before or during the inhibition period.
------ Door Lock Operation Resumes, Start / Stop in Toggle
NOTE :
•
The “INHIBIT” LED (Red) is ON in inhibition and turns to Flashing while pause is into effect.
•
See
Programming Locations 55 & 56
for more information of Daily Inhibition.
4) Inhibit All The User Codes & EM Cards for Output 1 (Disable Access Control Manually)
To enhance the security of the access control keypad, the owner can stop the keypad after office hour
or while the house is nobody inside. Once the Output 1 (for door lock control) is inhibited, all the User
Codes / Cards for it become invalid and those people holding the User Code or Card are refused. This
function Starts / Stops in toggle with the following code entry.
------ Door Lock Operation Inhibited, Start / Stop in Toggle
NOTE :
•
The door is locked during Output 1 inhibited and the “INHIBIT” LED (Red) is ON.
•
Inhibition applies to all User Codes and EM Cards for Output 1 only. Output 2 is not affected.
SUPER USER CODE
REMARK :
While SUPER USER CODE
is in operation to hold the door lock open, the functions that rely
on the door sensor (such as a magnetic contact) and the User Codes for output 1 are all temporarily
suspended until SUPER USER CODE
is keyed in again to release the door hold function.
The following are the temporarily suspended functions:
●
Door Auto-relock
●
Door Forced Open Warning (at Location 80)
●
Door Propped-up Warning (at Location 81)
●
Door Opening Alarm (at Location 91)
●
Dual Keypad Inter-lock Operation
●
All User Codes Including Super User Code for Output 1
●
Duress Output Actuated by The Duress Code for Output 1
SUPER USER CODE
