Advantech PPC-57 Series, Manual

Page: 84 / 108

7 4 PPC-57 User's Manual
DOS setup
Step 1: Install Windows as you normally would for a VGA display.
Run Windows to make sure that it is working correctly. Then exit
Windows.
Step 2: Place the display driver diskette in drive A. Type A:
<ENTER> to make this the default drive. Type SETUP <ENTER> to
run the driver SETUP program. Press any key to get to the applica-
tions list. Using the arrow keys, select Windows Version 3.1 and
press the <ENTER> key. Press the <ENTER> key to select All
Resolutions, and then press <END> to begin the installation. At
this point you will be asked for the path to your Windows System
directory (default C:\WINDOWS). When the installation is com-
plete, press any key to continue. Press <ESC> followed by Y to exit
to DOS.
Step 3: Change to the directory where you installed Windows
(usually C:\WINDOWS).
Step 4: Type SETUP <ENTER> to run the Windows Setup program.
It will show the current Windows configuration. Use the up arrow
key to move to the Display line and press <ENTER>. A list of
display drivers will be shown. Use the arrow keys to select one of
the drivers starting with an asterisk (*) and press <ENTER>.
Step 5: Follow the directions on the screen to complete the setup.
In most cases, you may press <ENTER> to accept the suggested
option. When Setup is done, it will return to DOS. Type WIN
<ENTER> to start Windows with the new display driver.
Changing display drivers in DOS
To change display drivers from DOS, change to the Windows
directory and run Setup, repeating steps 4 and 5 above. Apart from
the special display drivers marked by an asterisk (*), you should be
able to use the following standard drivers:
VGA 640 x 480, 16 colors
Super VGA 800 x 600, 16 colors