Advantech PPC-57 Series, Manual

Page: 67 / 108

Chapter 5 Software Configuration 57
ETHERNET.EXE
This is a compressed file containing ethernet drivers and the utility
for the Realtek 8019AS chip (see page 58).
5.3 How to Update BIOS
You can program your on-board BIOS as follows:
1. Apply power to the PCM-3866 with a color STN display
attached. This is the default setting for the PCM-3866. Make
sure that the AMIFLASH.EXE and *.ROM files are located in
the working drive.
Note: Make sure that you do not run AMIFLASH.EXE
while your system is operating in EMM386 mode.
2. At the prompt, type AMIFLASH.EXE and press <Enter>. The
VGA configuration program will then display the VGA Setup
screen.
3. At the prompt, type in the ROM file which supports your
display. When you are sure that you have entered the file name
correctly, press <Enter>. The screen will display "Flash
EPROM programming is going to start". If you wish to
continue, press Y. If you change your mind or have made a
mistake, press N to abort and end the setup procedure.
4. When programming is finished, press any key to reboot.
The new VGA configuration will then write to the ROM BIOS
chip. This configuration will remain the same until you run the
AMIFLASH.EXE program and change the settings.