Advantech PPC-102, Manual, Page: 92 / 126

78 PPC-102 User's Manual
6.7 OS/2 Drivers Setup Procedure
6.7.1 Preliminary steps
The following steps must be performed before you install the display
driver:
1. OS/2 DOS Support must be installed.
2. If you previously installed SVGA support, you must reset the system
to VGA mode. VGA is the default video mode enabled when OS/2 is
installed.
To restore VGA mode, use Selective Install and select VGA for Primary
Display. For more information on this procedure, see the section on
Changing Display Adapter Support in the OS/2 User’s Guide.
6.7.2 Installing from diskette
To install this driver, do the following steps:
1. Open an OS/2 full screen or windowed session.
2. Place the Display Driver Diskette in drive A.
3. At the OS/2 command prompt, type the following commands to copy
the files to the OS/2 drive:
Type:
A: <ENTER> to make this the default drive.
SETUP A: C: <ENTER>
where A: is the floppy disk drive; and
C: is the hard disk partition containing the OS/2 subdirectory
When the Setup Program is completed, you will need to perform a
shutdown and then restart the system in order for changes to take effect.
A log of the information output during the installation can be found in
<root>:\OS2\INSTALL\DISPLAY.LOG