Advantech PPC-102, Manual

Page: 89 / 126

Chapter 6 PCI SVGA Setup 75
6.4.2 DOS setup
Step 1: Install Windows as you normally would for a VGA display. Run
Windows to make sure that it is working correctly. Then exit Windows.
Step 2: Place the display driver diskette in drive A. Type A: <ENTER>
to make this the default drive. Type SETUP <ENTER> to run the driver
SETUP program. Press any key to get to the applications list. Using the
arrow keys, select Windows Version 3.1 and press the <ENTER> key.
Press the <ENTER> key to select All Resolutions, and then press <END>
to begin the installation. At this point, you will be asked for the path to
your Windows System directory (default C:\WINDOWS). When the
installation is complete, press any key to continue. Press <ESC> followed
by Y to exit to DOS.
Step 3: Change to the directory where you installed Windows (usually
C:\WINDOWS).
Step 4: Type SETUP <ENTER> to run the Windows Setup program. It
will show the current Windows configuration. Use the up arrow key to
move to the Display line and press <ENTER>. A list of display drivers
will be shown. Use the arrow keys to select one of the drivers starting
with an asterisk (*) and press <ENTER>.
Step 5: Follow the directions on the screen to complete the setup. In most
cases, you may press <ENTER> to accept the suggested option. When
Setup is done, it will return to DOS. Type WIN <ENTER> to start
Windows with the new display driver.