Installation and Operation Manual
54
4-9 Others
Press and
then
Others:
4-9-1 Simulate
Simulate :
Turn the simulate mode on or off.
Mode :
See 2-4 Simulate Mode.
Speed :
The simulated boat speed to use.
Course :
The simulated course over ground.
Route :
The route to follow.
4-9-2 Waypoint
Select a way to display waypoints.
4-9-3 GPS
See 4-4 GPS Settings.
4-9-4 Units
Select a unit of each measure.
Tip:
Requires a optional VHF receiver
with barometer connected
:
InHg or mB.
4-9-5 Comms
Use this feature when the unit is connected
to other marine electronics through any
compatible NMEA instrument.
NMEA0183/NMEA2000:
This option to
transmit NMEA sentences to other marine
electronics. NMEA0183 and NMEA2000
interfaces are generally used with third party
marine electronics. Select a port (NMEA2000,
NMEA0183-Port 1 or NMEA0183-Port 2), a
communication speed and select a desired
output data.
4-9-6 Calibrate
Speed :
Calibrate the boat speed. Travel at a
constant known speed and press
or
to calibrate the speed.
Speed filter :
Set this option when removing
effects from waves and wind which affect the
speed of boat by averaging.
Temperature :
Calibrate the water
temperature. Measure the water temperature
with thermometer then press
or
to
calibrate the temperature.
Temperature filter :
Set this option when
removing effects form water turbulence and
currents cause the water temperature to
fluctuate slightly.
Keel offset:
A depth measured by a
transducer is depending on where the
transducer is installed. You can adjust the
depth of water in consideration of depth of
transducer installed in the water.
Speed range:
Set a maximum speed of boat
that can be read in the unit.
4-9-7 Time
Local offset :
The time information supplied
by the GPS satellites is in UTC (Universal
Time Coordinates). To read the correct time,
change the time of GPS chart plotter for
daylight saving time start and end.
Time format :
Select the format of time.
Date format :
Select the format of date.
4-9-8 Restore default
Returns every other setting to default.
