ADVANCED UV LIGHT ELIXIR, Owner'S Manual

Page: 22 / 54

Original Dr. Müller ®
ORIGINAL DR. MÜLLER HIGH PERFORMANCE TANNING EQUIPMENT
22
Control
DANGER
UV- RADIATION!
UV- rays can cause serious
injuries to the eyes. Always wear
protective eye wear during a
tanning session.
UV-rays can cause serious
damage to your skin. Avoid
overexposure – always oberserve
recommended exposure times
according to your skin type.
Control with coinbox control device
 Insert coin or token.
The sunbed starts up.
 Open the top.
 Lay down on the sunbed bench.

Close the top.
 If you want to shorten pre-set delay time, push “Start“ on
the control panel.
The tanning session starts.

Select individual preference for intensity of body cooling
fan, facials, and – optionally – SunHaze aroma device
and A/C unit.
The tanning session stops after pre-set tanning time has run
out.

Switch off the Ionizer, the aroma device and the A/C unit.

Put the facials and the body cooling fan back into highest
intensity position
 Open the top and leave the sunbed.
 Clean and disinfect the sunbed as described in the
chapter "Cleaning" on page 36.
Control without coinbox control device
 Open the top.
 Lay down on the sunbed bench.

Close the top.
The display shows maximum tanning time.

If you want to shorten maximum tanning time, push the
”Set Time“-button on the control panel until the display
shows selected tanning time.

Push the “Start“ button.
The tanning session starts. The display shows run-out tanning
time.

If you want to interrupt the tanning session, push the
“Start“-button again.
The tanning session stops.
 If you want to continue the tanning session, push the
“Start“-button again.
The tanning session continues.
The tanning session stops after pre-set tanning time has run out.

Switch off the ionizer, the SunHaze aroma device and the
A/C unit.
 Put the body cooling fan and the facials back into highest
intensity position.
 Open the top and leave the sunbed.

Clean and disinfect the sunbed as described in the
chaper
“Cleaning ” on page 36.
The Emergency Stop Button
In an emergency situation the unit can be switched off by
pushing the Emergency Stop Button. UV light emission stops
immediately. The main ventilation stops after a short delay
time.
 Push the Emergency Stop Button.
The sunbed stops the tanning session. UV-light emission
stops immediately.

Open the top and leave the sunbed.
 Inform the operator of the sunbed.
In order to resume operation of the sunbed, the Emergency
Stop Button must be unlocked.
 Turn the red knob of the Emergency Stop Button clockwise
by approx. 90 degrees.