ADTRAN 1203086L1, Manual

Page: 22 / 162

Quick Start Guide
Quick Start-2 ISU 512e User Manual 61203086L1-1
Press
Cancel
to exit to the status screen and verify
READY
condi-
tions for each BRI line configured. If the status screen reads
S
YNC
,
D
OWN
,
TEI
, or
SPID ,
either the configurations of the switch proto-
col and SPIDs are incorrect or there may be a problem with the
ISDN line or translations (see Troubleshooting on page 8-1).
To configure the ISU 512e using the VT 100 terminal interface, use the
following procedure:
1. Connect a VT 100 async terminal, or personal computer with a
terminal emulator running 9600 8-N-1, to the EIA232 MAINT
PORT
.
2. Hold down the
Control
key and press
R
, and then press
Enter
to
display the top level menu.
3. Using the arrow keys and
Enter
key to navigate the menus, go to
the C
ONFIGURATION
/N
ETWORK
O
PTIONS
/D
IAL
L
INE
/ISDN menu.
Enter the SPIDs, LDNs, and Switch Protocol.
4. Use the left arrow or
Escape
key to go back up the menu tree.
When asked to save the ISDN parameters, type
Y
.
5. Connect the ISDN lines.
Service Profile/
Directory Number Line Interface Maximum Bandwidth
SPID1/LDN1
SPID2/LDN2 Line 1 128 kbps
SPID3/LDN3
SPID4/LDN4 Line 2 256 kbps
SPID5/LDN5
SPID6/LDN6 Line 3 384 kbps
SPID7/LDN7
SPID8/LDN8 Line 4 512 kbps
If the menu does not appear after performing step 2, ensure
that the correct COM port is selected on the computer and
functioning properly. Then try step 2 again.