Adtech QS7 Series, Manual

Page: 38 / 56

Single-channel all-digital AC servo drives QS7 Series
33
P55 Drift angle

Only if motor type is set to be
（
P2=9999
）
, this self-
defined parameter will be valid.

Set value refers to drift angle between motor angle and
zero point;

Please note that this parameter will be valid after it is
modified and saved, and then restart the machine;

Default value is 2360.
0
－
2500
P56 Rated
current 
Only if motor type is set to be
（
P2=9999
）
, this self-
defined parameter will be valid.

Set value refers to the motor rated current size, to only
impact on the protective function of motor current
without impact on motor operational effect;

Setup unit
（
0.1A
）
.
0
－
100
P57 Rated
torque 
Only if motor type is set to be
（
P2=9999
）
, this
parameter will be valid.

Set value refers to the motor rated torque size, to only
impact on the protective function of torque control
without impact on motor operational effect;

Setup unit
（
0.1A
）
.

Self-defined unit (0.1Nm)
0
－
200
P58 second
electronic
gear radio
numerator use method is same as first electronic gear radio .
P59 second
electronic
gear radio
denominat
or use method is same as first electronic gear radio .
0
－
1
P60 filter
coefficient adopt to remove the motor voice lead by speed loop gain too
big 0—9
P61 Drive
current
type 0 refers to QS6AA015M above; 1 refers to QS6AA010M.
0
－
1
P62 V-phase
current
zero
correction It refers to drift value of V-phase current zero
2008
－
2088
P63 W-phase
current
zero
correction It refers to drift value of W-phase current zero
2008
－
2076
Note:

It is recommended that all parameter settings and modification should be implemented
when the motor is prohibited.

All parameters (only P2 parameter will be effective after re-electrified when disconnecting
power) settings will be effective after just pressing "Enter", without re-electrifying;
however, parameter writing should be performed for long-term preservation;